Clearness and maintenance of the hottest ceramic a

Clarity and maintenance of ceramic roller

applicable performance:

ceramic roller is a key component in flexographic printing machine, offset printing machine glazing unit, corrugated box printing machine, coating machine, etc. 5. Jg/t 24 (2) 000 synthetic resin lotion sand wall architectural coating equipment. In the process of printing, glazing and coating, water-based ink, glazing oil and coating often gradually form a curing layer in the roller hole and block the hole, thus affecting printing Glazing and coating effect. However, it is generally difficult to clean the solidified layer that blocks the cavity. This cleaning agent is a new professional cleaning agent for colloidal ceramic roller. It is characterized by convenient use and remarkable effect. It does not need any auxiliary settings. It can remove the curing layers such as ink, varnish and paint in the hole in a short time, and restore it to a clean ceramic roller, maintaining its original ink transfer and coating effect

usage:

first, please wear rubber gloves and safety glasses before using this cleaning agent

II. Note: the surface of the cleaned ceramic roller is required to be dry. If there is water on the surface of the roller, the cleaning effect will be affected. Be sure to use a dry cloth to wipe the moisture on the roller

third, open the cleaning agent. Due to the local timely compensation, it is a farsighted strategy to sharply reduce the cross-sectional area of the packaging bottle. Apply the cleaning agent evenly on the surface of the corrugated roller with a brush. The cleaning agent must completely cover the surface of the corrugated roller without losing temperature while implementing system management and performance evaluation. The coating thickness is about 0.5 ~ 1mm. Then screw the cap of the detergent bottle tightly to avoid affecting future use

IV. please wait for about 15 minutes, when you can find that the detergent has been stained with ink. Then use the special steel wire brush for the corrugated roller to brush the whole surface of the corrugated roller step by step and evenly by means of reciprocating rotation. The purpose of this is to let the detergent wash out the residue at the bottom of the hole. Then, you can use a small amount of water to gradually brush off the cleaning agent and residual solidified matter on the surface of the corrugated roller by relying on the special wire brush for the corrugated roller

v. finally, rinse the surface of the corrugated roller with clean water and wipe the surface of the corrugated roller dry. At this time, you can see that the cleaned corrugated roller shows the true color of cermet, and the whole cleaning process is completed

VI. if it is found that there are still a small amount of traces of solidified substances such as ink on the surface of the corrugated roller, first wipe the water on the surface of the corrugated roller completely, and then repeat the cleaning procedure of 2 ~ 4. Brush the places with traces of solidified substances such as ink several times. At this point, we will be able to get a clean ceramic roller